Sakura Tissue-Tek TEC 6 User Manual

2. Installation
39
2. Select on which side of the Embedding Module the Cryo Module is
placed, according to your desired work flow. (The cables will be
connected to the rear of the instrument, so do not place the instrument
close to the walls yet.)
Connecting the Cables
1. Conrm that the respective power switch of the Embedding Module and
Cryo Module has been turned OFF.
2. Connect the control cable while paying attention to the insertion direction.
3. Insert the power cord of each module into an applicable power inlet.
Work Flow Work Flow

Sakura Tissue-Tek TEC 6 Specifications

General

Brand	Sakura
Model	Tissue-Tek TEC 6
Category	Control Unit
Language	English