Samson 3730 Series - Page 66

66 EB 8389-1S EN
Leakage sensor
START-UP
Prerequisite
– Activate CLOSED end position: On
â
Recording threshold
â
Alarm settings (NE 107)
Course of end position
x [%]
t [s]
0
PROCESS
Valve signature complete?
u Section 4.1
ß NO
YES
â
à
F
irst zero point =
Reference
à
Subsequent zero calibration over
Code 6 - ZP
à
Zero calibration
ß
Zero shifted monotonically increasing/decreasing,
alternating
â
Status classication (NE 107)/logged by operating hours counter
Course of end position
â â
á
Reset 'Reference values for course of
lower end position'
Reset 'Course of lower end position'
Course of end position