Samson 3730 Series - Page 206

16-18 EB 8384-3 EN
Error codes – Recommended
action
Condensed state message active, when prompted, Err appears.
Whenfaultalarmsexist,theyaredisplayedhere.
81 Reference graphs Error occurred during plotting the reference graphs for drive signal y
steady-state or drive signal y hysteresis.
• Reference test canceled
• Reference line for drive signal y steady-state or drive signal y
hysteresis was not adopted.
Error messages are not yet saved in a non-volatile memory. They cannot
be reset.
Statusclassication [No message]
Recommended action Check and, if necessary, perform a new reference test.