LED R&D Lab(VD)
111
③ After hanging the ASSY COVER P-REAR, remove the BRACKET-PLATE.
- Refer to the existing installation manual and mount the ASSY COVER P-REAR on the installed wall mount
- Remove 3 TOP points and 1 BOT point for each RIGHT/LEFT part. * Refer to the figure below
Fig.1 ASSY COVER P-REAR Extension Installation
Figure 2 TOP Part: BRACKET-PLATE Remove each 3EA left and right
BRACKET-PLATE removing point
Unscrew 2EA to remove.
Figure 3 BOT Part: Removal of 1EA on the left and right sides of BRACKET-PLATE
Frame Installation and Side Link connection
BRACKET-PLATE removing point
To Next Page
Loading...
