LED R&D Lab(VD)
18
Fig.5 remove Cover Corner
Al-Bag
Bag Zipper open
SCREW POINT
PAD
When moving the module, two people move
the module vertically
as shown in the figure
above.
side VIEW
2. preparation of Cabinet installation
④ Open the bag shielding of the front module. Hold the internal COVER-CORNER, take out the set, and
open the AL-Bag and disconnect the AL screws (4 in total).
(Fig.4)
⑤ Disconnect the screw of the COVER-CORNER part. (4 locations) (Fig.5)
※ When removing the cover-corner, install the white PAD without disassembling it to prevent damage to the front module.
◆ Pre-prepare before installation
Fig.4 Before screen check,
remove PAD and attach SPACER-EVA
Carefully place the module on the PAD.
To Next Page
Loading...
