Samsung BD-D5500 - Case 4: Connecting to a TV with an Audionideo Cable - Good Quality

Case 4 : Connecting to a TV with an AudioNideo cable - Good Quality
::!. ;;
~~. ; .;"":,";": H ".d
t
@
t
~
",,, ",,:, .,7
.; "; l _~_
Red White Yellow
1. Using an AudioNideo cable, connect the VIDEO OUT (yellow) / AUDIO OUT (red and white)
terminals on the rear of the player to the VIDEO IN (yellow) / AUDIO IN (red and white) terminals of
your1V.
2. Turn on the player and 1V.
3. Press the input selector on your 1V remote control until the "VIDEO" signal from the player appears
on the 1V screen.
• If you have set the remote control to operate your 1V (See page 19), press the TV SOURCE
button on the remote control and select VIDEO as the external source of the 1V.
~ NOTE
• Noise may be generated if the audio cable is placed too close to the power cable.
• If you want to connect to an AV Receiver, please refer to the AV Receiver connection pages, (See pages 24-25)
• The number and position of input terminals may vary depending on your 1V set Please refer to the user manual of your
1V,
• If there is only one audio input terminal on the 1V, connect it to the AUDIO OUT (right/white) terminal of the player.
CAUTION
• Do not connect the player to your 1V through a VCR. Video signals fed through VCRs may be affected by copyright
protection systems and the picture will be distorted on the television.
English 23