65
Chapter 5. Menu
Automatic Network Settings (Wired)
Connect to the network using a LAN cable.
Make sure a LAN cable is connected rst.
How to set up automatically
1 Press the
MENU
button on the remote control.
2 Select Network - Open Network Settings.
3 Select Wired.
‒ The network test screen appears and then the verication process starts.
4 When the connection has been veried, select OK.
• If the connection process fails, check the LAN port connection.
• If the automatic process cannot nd the network connection values or if you want to
set the connection manually, go to the next section, network setup.
Manual Network Settings (Wired)
Ofces may use static IP addresses.
If this is the case, ask the network administrator for the IP address, subnet mask,
gateway and DNS server address. Enter these values manually.
Getting the Network Connection Values
To view the Network connection values on most Windows computers, follow these
steps.
1 Right click the Network icon on the bottom right of the screen.
2 In the pop-up menu that appears, click Status.
3 On the dialog that appears, click the Support tab.
4 On the Support Tab, click the Details button. The Network connection values are
displayed.
How to set up manually
1 Press the
MENU
button on the remote control.
2 Select Network - Open Network Settings.
3 Select Wired.
‒ The network test screen appears and then the verication process starts.
4 Select Stop. The verication process stops.
5 Select IP Settings. The IP Settings screen appears.
6 Select IP Setting and set it to Enter Manually.
‒ Setting IP Setting to Enter Manually automatically changes DNS Setting to Enter
Manually.
7 Enter the network connection values.
‒ IP Address, Subnet Mask, Gateway, DNS Server.
8 When done, select OK at the bottom of the page, and then press . The network
test screen appears and the verication process starts.
9 When the connection has been veried, select OK.
To Next Page
Loading...
Need help?
General
