Samsung PM55F-BC User Manual

73
Chapter 5. Menu
Anynet+ (HDMI-CEC)
Anynet+ (HDMI-CEC)
Anynet+ is a function that enables you to control all connected Samsung devices
that support Anynet+ with your Samsung product remote. The Anynet+ system can
be used only with Samsung devices that have the Anynet+ feature. To be sure your
Samsung device has this feature, check if there is an Anynet+ logo on it.
• You can only control Anynet+ devices using the product remote control, not the
buttons on the product.
• The product remote control may not work under certain conditions. If this occurs,
reselect the Anynet+ device.
• Anynet+ works when the AV device supporting Anynet+ is in the standby or on
status.
• While in PIP mode, Anynet+ functions only when an AV device is connected as
the primary display. It does not work if the AV device is connected as a secondary
display.
• Anynet+ supports up to 12 AV devices in total. Note that you can connect up to 3
devices of the same type.
Troubleshooting for Anynet+
Problem Possible Solution
Anynet+ does not
work.
• Check if the device is an Anynet+ device. The Anynet+
system supports Anynet+ devices only.
• Check if the Anynet+ device power cord is properly
connected.
• Check the Anynet+ device’s Video/Audio/HDMI cable
connections.
• Check whether Anynet+ (HDMI-CEC) is set to On in the
System menu.
• Check whether the remote control is Anynet+
compatible.
• Anynet+ doesn’t work in certain situations. (initial
setup)
• If you have removed and then reconnected the HDMI
cable, please make sure to search devices again or turn
your product off and on again.
• Check if the Anynet+ function of the Anynet device is
set on.
I want to start
Anynet+.
• Check if the Anynet+ device is properly connected to
the product and check if the Anynet+ (HDMI-CEC) is set
to On in the System menu.
I want to exit Anynet+.
• Press the
SOURCE
button on the product remote control
and select a non- Anynet+ device.
The message
“Disconnecting
Anynet+ device ...”
appears on the screen.
• You cannot use the remote control when you are
conguring Anynet+ or switching to a view mode.
• Use the remote control after the product has
completed Anynet+ conguration or has nished
switching to Anynet+.

Samsung PM55F-BC Specifications

General

Brand	Samsung
Model	PM55F-BC
Category	Monitor
Language	English