66
Chapter 5. Menu
Network Setting (Wireless)
Connecting to a Wireless Network
Wireless IP sharer
(router having DHCP
server)
LAN port on the
wall
LAN cable
Samsung recommends using IEEE 802.11n. When you play video over a network
connection, the video may not play smoothly.
• Select a channel for the wireless IP sharer that is not currently being used. If the
channel set for the wireless IP sharer is currently being used by another device
nearby, this will result in interference and communication failure.
• Your product supports only the following wireless network security protocols.
If you select the Pure High-throughput (Greeneld) 802.11n mode and the
Encryption type is set to WEP, TKIP or TKIP AES (WPS2Mixed) on your AP or wireless
router, Samsung products will not support a connection in compliance with new Wi-
Fi certication specications.
• If your wireless router supports WPS (Wi-Fi Protected Setup), you can connect to
the network via PBC (Push Button Conguration) or PIN (Personal Identication
Number). WPS will automatically congure the SSID and WPA key in either mode.
• Connection Methods: You can setup the wireless network connection in three ways.
Auto Setup (Using the Auto Network Search function), Manual Setup, WPS(PBC)
Automatic Network Setup (Wireless)
Most wireless networks have an optional security system that requires devices
that access the network to transmit an encrypted security code called an Access or
Security Key. The Security Key is based on a Pass Phrase, typically a word or a series
of letters and numbers of a specied length you were asked to enter when you set up
security for your wireless network. If you use this method of setting up the network
connection, and have a Security Key for your wireless network, you will have to enter
the Pass Phrase during the the automatic or manual setup process.
How to set up automatically
1 Press the
MENU
button on the remote control.
2 Select Network - Open Network Settings.
3 Select Wireless.
‒ The network function searches for available wireless networks. When done, it
displays a list of the available networks.
4 In the list of networks, press the or button to select a network, and then press
.
‒ If the desired wireless router does not appear, select Refresh to search again.
‒ If the router cannot be found after retrying, select the Stop button. The Add
Network button appears and you can set the network manually.
5 If the Enter password screen appears, go to step 6. If you select a wireless router
that does not have security, go to step 8.
6 If the router has security, enter the password. (Security key or PIN).
7 When done, use the button to move the cursor to Done, and then press . The
network test screen appears and then the verication process starts.
8 When the connection has been veried, select OK.
To Next Page
Loading...
Need help?
General
