Samsung SCD67 - Zero Memory Function (SCD70 Only)

IENGLISHI
Playing back a Tape
ZERO MEMORY (SCD70 only)
The ZERO MEMORYfunction works in both CAMERA and PLAYER modes.
You can mark a point on a tape that you want to return to following playback.
1.
Press the ZERO MEMORY button onthe remote control during playbackor recording at the point
you want to return to later.
• The time code is changed to a tape counter that is set to zero with the [] (Zero memory indicator).
• If you want to cancel the zero memoryfunction, pressthe ZERO MEMORYbutton again.
2.
Find the zero position.
• When you finish playback, fast forward or rewind the tape.
- The tape stops automatically when it reaches the zero position,
• When you finish recording, turn the power switch PLAYERand press the _ (REW) button.
- The tape stops automatically when it reaches the zero position.
3. The tape counter with the [] (Zero memory indicator) disappears from the display and
the tape counter is changed to time code.
SP STOP
SP REW
• In the following situations, the ZERO MEMORY mode may be canceled automatically
- After returningto the zero position.
- When the tape is ejected.
- When you remove the battery pack or power supply,
• The zero memory may not function correctly where there is a break between recordings on the tape.
• The ZERO MEMORYwill not operate in DV IN mode.