Maintenance
IENGLISH_
+ At the end of a recording you must remove the power source.
+ Leaving the battery pack on the camcorder after completing recording can reduce the life span of the battery.
After completing a recording session
1. Slide the EJECT switch in the direction of the arrow
• Opening the cassette door ejects the tape automatically.
• Wait until the tape is completely ejected.
2. After removing the tape, close the door and store the camcorder in a dust free environment.
• Dust and other foreign materials can cause imagedegradation.
3. Set the power switch to OFF mode.
4. Disconnect the power source or remove the Lithium Ion Battery Pack.
• When connecting a power supply, separate it in reverse order by referring to page 21.
• Hold down the BATT,RELEASE button and slide the battery pack in the direction of the arrow.
To Next Page
Loading...
