Installation and Connection SVR-1630
Samsung Techwin
2004. 07. 2001 (v 1.0)
13
4.2 Connecting a Camera
(1) Connect a camera to the SVR-1630 using the coaxial cable as shown in the figure below.
<Note>
1.
The input video type should be either NTSC or PAL. Do not use both types at the same time.
2. Automatic setting of 75Ω terminal resistance
Two video terminals are internally connected. A terminal resistance of 75Ω exists when
only one terminal is connected. Hi-z exists when both terminals are connected.
See “9.6. Connecting Video In/Out ” on the page 42.
3. The Input Video Type (NTSC/PAL) is automatically recognized when the device runs.
For the recognition sequence, camera number 1 is recognized first, and then the sequence is decided
according to the camera signal type that is first detected, from cameras no. 1 to 16. When no cameras
are connected, the internal jumper setting is applied. To change the internal jumper, see page 61,
Appendix “2. Changing Video Type”
To Next Page
Loading...
