Installation and Connection SVR-1630
Samsung Techwin
2004. 07. 2001 (v 1.0)
29
9. Using Input/Output Terminals
<Note> Wiring
Terminating Wires
The wires for the TERMINAL BLOCK are terminated as described below. When solid and stranded
wires are used, be careful because the thickness of usable wires varies.
Stranded Wire: Strip the outer covering to the
defined length (8~10mm) and solder it.
Suitable wires are AWG 22 ~ 26.
Solid Wire: Strip the outer covering to the
defined length (8~10mm). Suitable
wires are AWG 20 ~ 26.
Inserting/removing wires
For inserting into or removing wires from the
TERMINAL BLOCK, push the lever as shown in
the figure.
To Next Page
Loading...
