SVR-1630 Installation and Connection
16
2004. 07. 2004 (v 1.0)
Samsung Techwin
4.5 Supplying Power and Running
(1) Connect the power cable as shown in the figure below.
<Note>
1. Connect the power cable, press the power switch, and the device starts booting.
2.Press and release the power switch while SVR-1630 is ON, the following windows are displayed
according to the system setting after 4 seconds.
When there is Admin password in “System Setup”
The dialogue box asking to enter the admin password is appeared. Enter the password, and the power is
off.
When there is no Admin password in “System Setup”
The dialogue box asking “Yes” or “No” is appeared. Select “Yes”, and the power is off.
3. For turning the power on again, press the power switch.
To Next Page
Loading...
