Samsung SVR-1630 - Recording Setup Configuration; Quick Recording Setup

Installation and Connection SVR-1630
Samsung Techwin
2004. 07. 2001 (v 1.0)
31
9.1.3 Setting Sensors
(1) Press the [MENU] button, and the OSD Configuration menu appears. Select “Event Source”.
(2) Go to the Sub-menu using the [ENTER] or
[▼] buttons. Select “Sensor” and press the [Enter] button
9.1.3.1 All Ch
Used for setting 16 sensors at the same time. Set the Off, or Normal Open (N.O.) / Normal Close (N.C.)
type.
(1) Select ‘All Ch’ and set the type.
(2) Press the “Apply” button to confirm the setting.
9.1.3.2 Configuration
Used for individually setting 16 sensors. Select and set each sensor.
(1) Select “Configuration” and press the [Enter] button.
(2) Select the sensor (S1~S16) to set and set the type.
(3) After setting, press the [ESC] key to return to the ODS menu.
<Note>
1. Sensor setting is for deciding whether to use sensors, and the sensor type. Storing according to sensor
inputs and relay should be set separately.
2. See “Event Rec.” of the “SVR-1630 User Manual”
for storing and “Event Act” for relay output.