CHAPTER THREE: TV OPERATION 3.7
OPERATION
Changing Channels
Using the Channel Buttons
1
Press the CH ▲ or CH ▼ buttons to change channels.
When you press the CH ▲ or CH ▼ buttons, the TV changes channels in
sequence. You will see all the channels that the TV has memorized. (The TV
must have memorized at least three channels.) You will not see channels that
were either erased or not memorized.
Directly Accessing Channels
Use the number buttons to quickly tune to any channel.
1
Press the number
buttons to go directly to a channel. For example, to select channel 27, press “2,”
then “7.” The TV will change channels when you press the second number.
When you use the number buttons, you can directly select channels that were
either erased or not memorized.
To select a channel over 100, press the +100 button. (For channel 122, press
“+100,” then “2,” then “2.”)
To change to single-digit channels (0–9) faster, press “0” before the
single digit. (For channel “4,” press “0,” then “4.”)
2
Press the Add/Erase button:
Repeatedly pressing this button will alternate between “Channel added” and
“Channel erased.”
You can view any channel (including an erased channel) by using the number
buttons on the remote control.
1
Use the number buttons to directly select the channel that will be added or erased.
Adding and Erasing Channels (Manual Method)
Using the Pre-CH Button to select the Previous Channel
1
Press the Pre-CH button.
The TV will switch to the last channel viewed.
To quickly switch between two channels that are far apart, tune to one channel,
then use the number button to select the second channel. Then, use the Pre-CH
button to quickly alternate between them.
01066D(E)-CHAPTER 3 4/12/05 9:26 AM Page 7
To Next Page
Loading...
