Santerno SINUS MINI Series - Page 34

SINUS MINI High performance Vector Control Inverter User Manual
33
12: Normally open terminal for inputting external
fault
13: Normally close terminal for inputting external
fault
14: Frequency increase command
15: Frequency decrease command
16: Free run to stop
17: Three-wire control
18: switch of speed given mode
19：Reset terminal for program operation
20: Start traverse operation
21：Pause traverse operation
22：DC braking command
23：Acc/Dec disabled command
24：switch between panel control mode and
external terminal control mode
25：switch between panel control mode and
communication control mode
26: Counter trig signal
27: Counter reset signal
28: PID dormancy waking up
29：switch between PID positive mode and negative
mode
30：emergence stop
F6.07
Terminal filter
times
1-100
10
F6.08
Operation
protection of power
on terminal
0:：protect
1：no protect
0