Santerno Sinus Penta - Nameplate; Installing the Equipment

SINUS PENTA
BASIC
USER MANUAL
12/97
2.2.1. NAMEPLATE
Typical nameplate for 4T SINUS PENTA Drives:
Figure 1: Nameplate of the SINUS PENTA Drive.
2.3. Installing the Equipment
The inverters of the SINUS PENTA series are Open Type Equipment – degree of protection IP00 and IP20 – that can be
installed inside another enclosure. Only models with degree of protection IP54 may be wall-mounted.
The drives must be installed vertically.
The ambient conditions, the instructions for the mechanical assembly and the electrical connections of the drives are
detailed in the sections below.
CAUTION
Install the drive in an upright position.
Do not install the drive horizontally or upside-down.
CAUTION
Do not mount any heat-sensitive components on top of the drive
to prevent them from
damaging due to hot exhaust air.
CAUTION
The drive rear wall may reach high temperatures; make sure that the drive
bearing
surface is not heat-sensitive.