Santerno Sinus Penta - Startup

BASIC
USER MANUAL
SINUS PENTA
3/97
0. STARTUP
NOTE
This manual covers basic installations of the Pent
a drive. For more details, please
refer to the standard Sinus Penta’s
Installation Instructions
manual.
NOTE
SINUS PENTA drives are factory set with the IFD control algorithm (V/f) allowing
performing the first startup of the equipment. The default func
tions are given in this
section, particularly in step
5) Start up
.
1) Inspection:
Check if the size of the Penta drive is greater than or equal to the size
of the connected motor
according to the drive nameplate. See the Delivery Check section.
2) Installation
and wiring:
The IP rating of the Penta drive is given in the Installing the Equipment section.
Ensure that sufficient
ventilation is provided to the drive. More details are given in the standard Sinus Penta’s
Installation
Instructions
manual.
3) Power on:
Power on the drive; check if the keypad turns on.
4) Parameter
setting:
For an easier startup of the Penta drive, you can activate the Start-Up Menu. The Start-Up Menu is a
wizard allowing programming the main parameters for the connected motor.
The Start-Up Menu is displayed when the Penta drive is first started. The Start-
Up Menu can be
reactivated at any time. To do so, set
P265
in “Start Up” mode:
[
I
D
P
]
S
I
N
U
S
P
E
N
T
A
S
T
A
R
T
-
U
P
M
E
N
U
P
r
e
s
s
E
N
T
E
R
t
o
s
t
a
r
t
Press Enter to enter the wizard.
Before entering the control parameters, you are asked to choose a dialogue language:
P
2
6
3
L
a
n
g
u
a
g
e
→
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
Then you are asked to choose the display mode of the Start Up Menu:
W
h
e
n
d
o
e
s
t
h
e
S
t
a
r
t
-
U
p
M
e
n
u
a
c
t
i
v
a
t
e
?
→
@
@
@
@
@
@
@
@
@
@
@
@
@
@
@
Choose one of the following:
1
:
E
V
E
R
Y
S
T
A
R
T
-
U
P
2
:
O
N
L
Y
N
O
W
3
:
N
E
X
T
S
T
A
R
T
-
U
P
4
:
N
E
V
E
R