Sanyo PLC-XF60A - Optical Parts Disassemblies

- 23 -
A
B
C
B
Optical Parts Disassemblies
z Mirrors & Optical Filter removal
A : (T4 x 10) x 2 on holder
B : (M4 x 8) x 4 on duct holder
C : (M3 x 10) x 4 on prism mirror
SEQ No. zxz
This chapter describes disassemblies procedure of the optical parts. Disasemblies should be made following to the
SEQ No. indicated on the right of each item.
Caution:
The parts and screws should be placed exactly the same position as the original otherwise it may cause loss of per
-
formance and product safety.
z ........ SEQ No. in Mechanical Disassemblies
z ........ SEQ No. in Optical Parts Disassemblies
Fig.1
Optical Filter-UV/IR
Optical Filter-UV/IR
Printed Part
No.(Behind)
Printed Part
No.
Mirrors
Printed Part
No.
(M3 x 8) x 3
(M3 x 8) x 3