Sanyo PLC-XR201 - XGA LCD Projector

41
Video Input
Use the Point ◄► buttons to adjust the gamma value to
obtainabetterbalanceofcontrast(from0to15).
Gamma
PressthePoint◄buttontodecreasethesharpnessofthe
image;pressthePoint►buttontoincreasethesharpness
oftheimage(from0to15).
Sharpness
An interlaced video signal can be displayed in progressive
mode.Selectoneofthefollowingoptions.
 Off.........Disabled.
 L1..........Foranactivepicture.
 L2..........Forastillpicture.
 Film.......Forwatchingafilm.Withthisfunction,the
projectorreproducespicturesfaithfultothe
originalfilmquality.
Progressive
Noise reduction
Noise interference on the screen can be reduced. Select
oneofthefollowingoptionstogetsmootherimages.
 Off.........Disabled.
L1..........Lowerreduction
 L2..........Higherreduction
Note:
 Noise reductionandProgressivecannotbeselected
when480p,575p,720p,1035ior1080iisselected
(p.38).
To reset the adjusted data, select Reset and press the
SELECTbutton.Aconfirmationboxappearsandthenselect
Yes.Alladjustmentswillreturntotheirpreviousfigures.
Reset
Store
Tostoretheadjusteddata,selectStoreandpressthethe
Point►ortheSELECTbutton.UsethePoint▲▼buttons
toselectonefromImage1to4andpresstheSELECT
button.
AconfirmationboxappearsandthenselectYes.Stored
datacanbecalledupbyselectinganImage (1–4)inthe
ImageModeSelectiononpage39.
Store Menu
Aconfirmationbox
appearsandthen
selectYes.