Sanyo PLC-XR201 - XGA LCD Projector

63
Problem: –Solutions
No power –PlugthepowercordoftheprojectorintotheACoutlet.
  –SeeifthePOWERindicatorlightsred.
  –WaituntilthePOWERindicatorstopsblinkingtoturnontheprojector
again.TheprojectorcanbeturnedonafterthePOWERindicator
turnsred.Seepage18.
  –ChecktheWARNINGindicator.IftheWARNINGindicatorlightsred,
   projectorcannotbeturnedon.Seepage58.
  –Checktheprojectionlamp.Seepage61.
  –UnlocktheKeylockfunctionfortheprojector.Seepage53.
The initial display is not shown. –MakesureOfforCountdown offarenotchosenatdisplay
   function.Seepage45.
The initial display is not same –MakesureUserorOffarenotchosenatLogo(select)
as the default set. function.Seepage46.
Input signal switches automatically. –MakesureInputsearchfunctionisadjustedproperly.Seepage44.
(or does not switch automatically)
When the projector is on and you –ThatistheFilterwarningicon.Seepage56.
press the input source buttons,
an icon other than the Lamp mode
icon appears.
An icon other than Input mode or –ThatistheLampreplacementiconortheFilterwarningicon.See
Lamp mode icon appears. pages56or61.
Image is out of focus. –Adjustfocusoftheprojector.Seepage23.
  –Provideproperdistancebetweentheprojectorandtheprojection
   screen.Seepage12.
  –Checktheprojectionlenstoseeifitneedscleaning.Seepage60.
  –Movingtheprojectorfromacooltowarmplacemayresultin 
   moisturecondensationontheprojectionlens.Insuchcases,leave
   theprojectoroffandwaituntilcondensationevaporates.
Image is Left/Right reversed. –ChecktheCeiling/Rearfunction.Seepage49.
Image is Top/Bottom reversed. –ChecktheCeilingfunction.Seepage49.

Picture is not bright enough. –CheckiftheContrastorBrightnessisadjustedproperly.See
   pages33,40.
  –CheckifImage modeisselectedproperly.Seepages32,39.
  –Checkthelampcontrolfunction.Seepages25,52.
  –ChecktheLAMPREPLACEindicator.Ifitlights,theendoflamplife
   isapproaching.Replacethelampwithanewonepromptly.Seepage
   61.
Appendix
Troubleshooting
Beforecallingyourdealerorservicecenterforassistance,checktheitemsbelowonceagain.
–Makesureyouhaveproperlyconnectedtheprojectortoperipheralequipmentasdescribedonpages14-16.
–MakesureallequipmentisconnectedtoACoutletandthepoweristurnedon.
–Whentheprojectordoesnotprojectanimagefromtheconnectedcomputer,restartthecomputer.