Sanyo PLC-XR201 - XGA LCD Projector

64
Appendix
No image –Checktheconnectionbetweenyourcomputerorvideoequipment
   andtheprojector.Seepages14-16.
  –Seeiftheinputsignaliscorrectlyoutputfromyourcomputer.Some
   laptopcomputersmayneedtochangethesettingformonitoroutput
  whenconnectingtoaprojector.Seeyourcomputer’sinstruction
   manualforthesetting.
  –Ittakesabout30secondstodisplayanimageafterturningonthe
   projector.Seepage18.
  –ChecktheInputsignal,colorsystem,videosystemorcomputer
systemmode.
  –MakesurethetemperatureisnotoutofthespecifiedOperating
   Temperature(41˚F–95˚F[5˚C–35˚C]).
  –WhenNo Showisoperating,theimagecannotbedisplayed.Press
   theNOSHOWbuttonoranyotherbuttonontheremotecontrol.
No sound –Checktheaudiocableconnectionfromaudioinputsource.
  –Adjusttheaudiosource.
  –PresstheVolume+button.Seepage24.
  –PresstheMutebutton.Seepage24.
  –WhentheAUDIOOUTisplugged-in,theprojector'sbuilt-inspeaker
   isnotavailable.      
  –Istheimageprojected?Youwillhearthesoundonlywhentheimage
   isprojected.
The color is strange. –ChecktheInputsignal,colorsystem,videosystemorcomputer
   systemmode.      
  –MakesuretheBlackboardisnotselectedonImageselect 
   menu.Seepages32,39.
Some displays are not seen –ChecktheDisplayfunction.Seepage45.
 during the operation.
 Auto PC adjustment function
 –ChecktheInputsignal.AutoPCadjustmentfunctioncannotwork
 does not work.  when480p,575p.720p,480i,575i,1035ior1080iisselected.See
  page29.

 The setting does not remain
 –MakesureyouselectedStoreafteradjustingsetting.Somesettings
 after turning off power.  cannotbestoredifnotregisteredwithStore.Seepages34,41.
 Power management does not –PowermanagementfunctioncannotworkwhileFreezeorNo
work.  Showfunctionisrunning.Seepage50.
 Capture function does not work. –Checktheconnectionandtheinputsignaltoseeifthereissignal.
 Auto setup does not work properly. – MakesureOffisnotselectedatanyfunctionof Auto setup.Seepage 
   44.
  –MakesureOnisnotselectedattheCeilingfunction.Seepage49.
Auto keystone function does not  –MakesuretheAutokeystonefunctionisnotsettoManual.Press
 work even when the projector is theAUTOSETUPbuttononthetopcontrol.Seepages23,44.
tipped. 
Appendix