Sanyo PLC-XU300 - Menu Bar Overview

22
Menu Bar
For detailed functions of each menu, see “Menu Tree” on pages 68-69.
q
w
e
r
t
y
u
i
Main Menu Sub-Menu
o
!0
e Image select
For computer source, used to select an image mode from among Dynamic, Standard, Real, Blackboard(Green),
Colorboard and image 1 - 4 (p.33).
For Video source, used to select an image mode among
Dynamic, Standard, Cinema, Blackboard(Green), Colorboard
and
Image 1- 4 (p.40).
r
Image adjust
For computer source, used to adjust computer image [
Contrast, Brightness, Color temp., White balance (R/G/B),
Sharpness and Gamma] (pp.34-35).
For Video source, used to adjust picture image [
Contrast, Brightness, Color, Tint, Color temp., White balance (R/G/
B), Sharpness, Gamma, Noise reduction and Progressive] (pp.41-42).
w PC adjust
Select Fine sync., Total dots, Horizontal, Vertical, Clamp, Display area H, Display area V and Auto PC adj. to adjust
the parameters to match with the PC input signal format (p.30-32).
t
Screen
For computer source, used to adjust size of the image [ Normal, True, Wide, Full, Custom and Digital zoom +/– ]
(pp.35-36). For Video source, used to set size of image [Normal, Wide, Custom] (p.43).
q Input
Used to select an input source from
Computer 1, Computer 2 ,Video or S-video . (pp.27-28,37-38).
y Sound
Used to adjust the volume or mute the sound (p.24).
i Information
Display the input source information: Input , H-sync freq., V-sync freq., Screen, Language, Lamp status, Lamp
counter , Power management, Keylock, PIN code lock and Remote control (p.58).
!0 Guide
The key operation is displayed.
u
Setting
Used to set the projector’s operating configurations (pp.44-57).
o Network
See owner’s manual of “Network Set-up and Operation”.
Basic Operation