Sanyo PLC-XU300 - Computer System Selection

29
PC System Menu
PC System Menu
Computer System Selection
This projector automatically tunes to various types of computers based on VGA, SVGA, XGA, SXGA, WXGA,
or UXGA with its Multi-scan system and Auto PC Adjustment. If a computer is selected as a signal source, this
projector automatically detects the signal format and tunes to project a proper image without any additional
settings. (Signal formats provided in this projector are shown on pages 71.)
One of the following messages may appear when:
The projector cannot recognize the connected
signal conforming to the provided PC Systems.
Auto is displayed on the System Menu box
and the Auto PC Adjustment function works
to display proper images. If the image is not
projected properly, a manual adjustment is
required (pp.31-32).
There is no signal input from the computer.
Check the connection between your computer
and the projector. (See “Troubleshooting” on
page 64.)
Auto
-----
The preset system is manually adjusted in the
PC Adjust Menu. The adjusted data can be
stored in Mode 1–5 (pp.31-32).
Mode 1
PC Systems provided in this projector is chosen.
The projector chooses a proper system provided
in the projector and displays it.
SVGA 1
*Mode 1 and SVGA 1 are examples.
1
2
PC system can also be selected manually.
Selecting Computer System Manually
Press the MENU button to display the On-Screen
Menu. Use the Point ed buttons to select Input and
then press the Point
8
or the SELECT button.
Use the Point
ed buttons to select Systerm and then
press the Point
8
or the SELECT button.
Use the Point ed buttons to select the desired system
and then press the SELECT button.
3
The PC System Menu
Selected system is
displayed.
Systems in this
dialog box
can be selected.
Customized
Mode
(1–5) set in the
PC Adjust Menu
(pp.31-32).
Computer Input