Sanyo PLC-XU300 - Input Source Selection (Component, RGB Scart)

38
Choose Computer 1(Component) or Computer 1(Scart) by pressing the INPUT button on the top control or
press the COMPUTER 1 or the COMPONENT button on the remote control.
Before using INPUT button, correct input source should be selected through Menu operation as described
below.
1
Input Menu
2
Use the Point ed buttons to select Computer 1 and
then press the Point 8 button.
Input Source Selection (Component, RGB Scart 21-pin)
When the input source is coming from video
equipment connected to the COMPUTER
IN 1/COMPONENT IN terminal with a
Component-VGA Cable, select Component.
Component
When the input source is coming from video
equipment connected to the COMPUTER
IN 1/COMPONENT IN terminal with a Scart-
VGA Cable, select RGB (Scart).
RGB (Scart)
Direct Operation
Menu Operation
Press the MENU button to display the On-Screen
Menu. Use the Point ed buttons to select Input and
then press the Point 8 or the SELECT button.
✔ Note:
When the Input Search function is set to
On1 or On2,
the input signal will be searched automatically (p.45).
COMPUTER 1 button
Top ControlRemote Control
3
Use the Point ed buttons to select Component or
RGB(Scart) and then press the SELECT button.
Computer 1(RGB)
Computer 1(Scart)
INPUT button
COMPONENT button
Computer 1
(Component)
Video Input
Video
Computer 2(RGB)
S-video
Computer 1(RGB) /
(Component) / (RGB(Scart))