-10-
Lamp Replacement
How to check Lamp Used Time
The LAMP REPLACE indicator will light yellow
when the total lamp used time (Corresponding
value) reaches 5,000 hours. This is to indicate
that lamp replacement is required.
You can check the lamp used time following
to the below procedure.
1 Press and hold the ON/STAND-BY
button on the projector or the remote control
for more than 20 seconds.
2 The projector used time and lamp used
time will be displayed on the screen briefly
as follows.
Counter
Projector 650H
Lamp
Auto 200H
Normal 150H
Eco1 250H
Eco2 250H
Corresponding value 750H
Total lamp used time
Projector used time
Warning Message on the non-standard lamp used
If the non-standard lamp is used, the warning and confirmation messages will appear on the screen every startup.
Some of the functions are limited when the non-standard lamp is used in spite of the warning.
Since the lamp is not standard,
projector failed to read lamp data.
Continue to use this lamp?
Yes
No
Cumulative
lamp
operating
time in each
mode.
To Next Page
Loading...
Need help?
General
