Sartorius Cubis MCA125P Series - Parameters in the Device Settings; Parameters in the Device Settings; Measurement Uncertainty Menu; Device ID Menu

80 Operating Instructions Cubis
®
MCA
System Settings
7.7.23 Parameters in the “Device Settings / Measurement Uncertainty” Menu
Parameter Setting Values Explanation
Active Off* If this extension has been activated in the QAPP Center:
Disables the measurement uncertainty.
On If this extension has been activated in the QAPP Center:
Activates the dynamic display of the measurement uncertainty
for the weight value.
Method User input If this extension has been activated in the QAPP Center:
Saves a name assigned for the method, e.g., EURAMET cg-18
Calibration
certificate
User input If this extension has been activated in the QAPP Center:
Saves a name assigned for the calibration certificate.
Date User input If this extension has been activated in the QAPP Center:
Defines the date of the measurement uncertainty.
Created by User input If this extension has been activated in the QAPP Center:
Saves the name of the user.
Accreditation User input If this extension has been activated in the QAPP Center:
Saves the name of the accreditation.
Displayed value Absolute uncertainty* If this extension has been activated in the QAPP Center:
Calculates the measurement uncertainty as an absolute value.
Relative uncertainty If this extension has been activated in the QAPP Center:
Calculates the measurement uncertainty as a relative value.
Process accuracy If this extension has been activated in the QAPP Center:
Calculates the measurement uncertainty according to the input
of the process accuracy factors.
Process accuracy
factor
Enter factor If this extension has been activated in the QAPP Center:
Saves the entry for the process accuracy factor.
Summand a(1) Enter summand If this extension has been activated in the QAPP Center:
Saves the entries for range 1.
Factor b(1) Enter factor
Exponent b(1) (e-) Enter exponent
Summand a(n) Enter summand If this extension has been activated in the QAPP Center:
Saves the entries for range n.
Factor b(n) Enter factor
Exponent b(n) (e-) Enter exponent
* Factory setting
7.7.24 Parameters in the “Device Settings / Device ID” Menu
Parameter Setting Values Explanation
Device ID 1 User input Saves the entered device ID.
Device ID 2 User input Saves the entered device ID.