60
Recalculation
Practical Example
When weighing in formulation components, the second component is over-poured.
Settings (changes in the factory settings required for this example):
Setup: App(lication parameters): Application 1: Recalculation
Step Key (or instruction) Display/Output
1. Delete previously stored values, c
if necessary
2. Place container for filling Place empty container
components on the scale on the scale
3. Tare t
4. Add the first component Weigh the first component
into the container
5. Store component Press the
Comp.1 Comp1 + 25.08 g
6. Add the second component Weigh the second component
into the container
7. Start recalculation, because
Recalc soft key
10.73 g were poured rather
than 10.60 g
8. Either press the minus
Minus soft key repeatedly
key to correct the value …
To Next Page
Loading...
