LED Status Lights
The heater module has two LED lights
on the front left corner that visually
indicate the status of the analyzer� The
left LED shows the status of the bal-
ance� The right LED indicates the status
of the heating function�
* = only for model LMA100P
Each LED may have three colors:
red, green or amber� Red is generally
associated with a warning state and
shows that corrective action must be
taken� Green is generally associated with
a positive condition, indicating you can
proceed� Yellow generally indicates
a transitional period or that the test
is in progress�
21
Warmup
Balance LED
Heater LED
Warming up
Rapidly flashing RED Rapidly flashing RED
Ready to test
Steady GREEN Steady GREEN
Heater in conserve mode
Steady GREEN Steady YELLOW
Standby
Balance LED Heater LED
Sample in chamber
heating cavity (chamber)
Flashing YELLOW Flashing GREEN
Equilibrating
Flashing YELLOW
Flashing YELLOW
Test mode Balance LED
Heater LED
Test in progress Steady YELLOW
Steady YELLOW
Test done
Flashing YELLOW Flashing GREEN
Sample loading
Below target
Flashing GREEN
Steady GREEN
Within target Flashing YELLOW
Steady GREEN
Above target Flashing RED
Steady GREEN
Diagnostics Balance LED
Heater LED
Failed diagnostics
Flashing RED
Flashing RED
To Next Page
Loading...
