Follow the instructions carefully when
unpacking the analyzer:
§ Unpack the analyzer carefully and
gently�
§ Remove all the contents of the carton�
Check carefully to make sure you have
removed all accessory items�
§ The device consists of two modules,
a control module and a heater module�
Heater modules may be connected to a
single control module�
§ Inspect each module for physical dam-
age and report any damage immediately
to Sartorius or the distributor that you
purchased the analyzer from�
§ Verify that you have received the
following accessories:
Instructions for Recycling
the Packaging
To ensure adequate protection for safe
shipment, your moisture analyzer has
been packaged to the extent necessary
using environmentally friendly materi-
als� After successful installation of the
moisture analyzer, you should return
this packaging for recycling because
it is a valuable source of secondary
raw material� For information on recy-
cling options, including recycling of
old weighing equipment, contact your
municipal waste disposal center or local
recycling depot�
Equipment Supplied
– Inter-module cable
– Power module cable
– Pan support
– Pan shield
– Power cord
– Tweezers
– Sample pans
– Operating instructions manual
Only model LMA100P:
– Roll of paper
– Paper spool & 2 end caps
9
To Next Page
Loading...
