SATO GY412 - Page 115

Section 3: Operation and Configuration
GY412 Operator Manual Page 3-87
3.3 LCD MESSAGE DETAILS (cont’d)
Display Service Mode - VR setting
Onscreen
message
This screen indicates the VR setting values on
the main PCB.
Displaying the following adjustment values.
“PITCH” : Shows the value of print offset volume
on both upper and lower surfaces.
“OFFSET” : Shows the value of cut offset volume.
“DARKNESS” : Shows the value of darkness vol-
ume.
Operation
button
Button Description
ENTER Goes to the [SET PASSWORD] screen.
CANCEL Goes to the [SERVICE MODE] screen.
FUNCTION Goes to the [SERVICE MODE] screen.
Display Service Mode - Password setting
Onscreen
message
Enabling/Disabling password entry when entering
each mode.
Use ← and → keys to move the cursor and press
ENTER.
The default setting is "OFF".
Operation
button
Button Description
↓, ↑ Moves the cursor.
ENTER “ON”: Goes to the [PASSWORD NO] screen.
“OFF”: Saves the setting and goes to the [SER-
VICE MODE] screen.
CANCEL Goes to the [OFFSET VOLUME] screen without
saving the setting.
FUNCTION Goes to the [SERVICE MODE] screen without
saving the setting.
OFFSET VOLUME
PITCH +0.00 mm
OFFSET +25 mm
DARKNESS 50
OFF
ON
SET PASSWORD