SATO GY412 - Page 81

Section 3: Operation and Configuration
GY412 Operator Manual Page 3-53
3.3 LCD MESSAGE DETAILS (cont’d)
3.3.1.7.2 USB Interface Board Setting
Display Interface Mode - USB communication protocol setting
Onscreen
message
Setting communication protocol.
Press ENTER.
The default setting is “STATUS4”.
Operation
button
Button Description
←, →, ↓,↑ Moves the cursor.
ENTER "STATUS4" : Saves the setting and goes to the
[ONLINE MODE] screen.
"STATUS5" : Saves the setting and goes to the
[ITEM NO CHECK] screen.
CANCEL Goes to the [INTERFACE PORT] screen without
saving the setting.
FUNCTION Goes to the [ONLINE MODE] screen without sav-
ing the setting.
STATUS4
PROTOCOL
STATUS5