SATO GY412 - Page 86

Section 3: Operation and Configuration
Page 3-58 GY412 Operator Manual
3.3 LCD MESSAGE DETAILS (cont’d)
Display Interface Mode - RS-232C character bit setting
Onscreen
message
Setting RS-232C character bit.
Use ← and → keys to move the cursor and press
ENTER.
The default setting is "8BIT".
[Important] Changed setting becomes effective at
next power-on.
Operation
button
Button Description
←, → Moves the cursor.
ENTER Saves the setting and goes to the [PROTOCOL]
screen.
CANCEL Goes to the [STOP BIT] screen without saving
the setting.
FUNCTION Goes to the [ONLINE MODE] screen without sav-
ing the setting.
Display Interface Mode - RS-232C communication protocol setting
Onscreen
message
Setting communication protocol.
Press ENTER.
The default setting is “STATUS4”.
Operation
button
Button Description
↓,↑, ←, → Moves the cursor.
ENTER "STATUS4" : Saves the setting and goes to the
[ONLINE MODE] screen.
"STATUS5" : Saves the setting and goes to the
[ITEM NO CHECK] screen.
"STATUS3" : Saves the setting and goes to the
[ONLINE MODE] screen.
CANCEL Goes to the [INTERFACE PORT] screen without
saving the setting.
FUNCTION Goes to the [ONLINE MODE] screen without sav-
ing the setting.
8BIT
CHARACTER BIT
7BIT
STATUS4
PROTOCOL
STATUS5
STATUS3