SATO M-8485Se - EX0 (Expanded Print Length)

BWaabbb Bar Codes. Expansion. Works together with the BT command to
specify an expansion factor and the bar code height for the particular
symbol being printed.
aa = Expansion factor by which the width of all bars and spaces
is increased (01-12)
bbb = Bar height by dot (004-600 dots)
5-16
BXaabbccdd
eeefffghh
Data Matrix. Data Format. Specifies the format of the Data Matrix 2-D
symbology.
aa = Format ID (01-16, The values 07 and 17 will not be
accepted)
bb = Error correction level (00, 05, 08,10,14, 20 or 200. All other
values processed as 00.
cc = Horizontal cell size (03-12 dots/cell)
dd = Vertical cell size (03-12 dots per cell)
eee = Cells per line. Must use 000 for optimized symbol.
fff = Cell lines. Must use 000 to optimize.
g = Mirror image
0 Normal Print
1 Reverse Print
hh = Guide cell thickness (01-15) 01 indicates normal type.
5-100
C Repeat Label. Prints a duplicate of the last label printed. 5-65
CSa Print Speed Selection. Specifies a unique print speed in in./sec.
through software for a particular label.
5-64
M-8459Se M-8460Se M-8485Se M-8490Se
a = Speed Setting 2=2ips
3=3ips
4=4ips
5=5ips
4=4ips
6=6ips
8=8ips
4=4ips
6=6ips
8=8ips
10=10ips
12=12ips
4=4ips
6=6ips
8=8ips
Dabbcccd Bar Codes. Prints 1:2 ratio bar code. For UPC and EAN bar codes,
this will add descender bars. For values a, bb, ccc and d see
instructions for Babbcccd.
5-11
DCxx...x Data Matrix. Print Data. Prints data using Data Matrix format specified
in BX Data Format command.
xx...x = Data to be printed. Cannot exceed 500 characters.
5-103
Eaaa Line Feed. Provides the ability to print multiple lines of the same
character size without specifying a new print position for each line.
aaa = Number of dots (1-999) between the bottom of the
characters on one line to the top of the characters on the
next line.
5-52
EX0 Expanded Print Length. Expands the print length to 9999 dots. 5-59
Faaaabcccc
ddee
Sequential Numbering. Allows the printing of sequencing fields (text,
bar codes) where all incrementing is done within the printer.
aaaa = Number of times to repeat the same data (0001-9999)
b = Plus or minus symbol (+ for increments; - for decrements)
cccc = Value of step for sequence (001-9999)
dd = No. of digits for sequential numbering (01-99, default = 8)
ee = No. of digits free from sequential numbering (01-99,
default=0)
5-72
PageA-3PN9001073RevCSATO“Se”PrintEngines
Appendix A: Command Quick Reference
INSTRUCTION DESCRIPTION PAGE