SATO s84ex - Page 240

5 Emulation Mode
238
S84-ex/S86-ex Operator Manual
SOP EMULATION
Set the types of Start of Print (SOP) emulation.
The options are as follows:
• AUTO: Auto selection based on the value set in <STX>O command.
• DISABLED: <STX>O command is ignored.
• PROD+ 110: Offset will be set by minus 110.
• ALLEG 220: Offset will be set by minus 220.
• PROD 250: Offset will be set by minus 250.
1-BYTE CODEPAGE
Select the code page to be used for 1 byte characters from the list.
The options are as follows:
• CP 850
• CP 858
• CP 1252
• UTF-8
• CP 88591
• CP 88592
• CP 88595
• CP 852
MEASURE UNIT
Set the measurement unit.
• Inch
• mm
COMPATIBILITY TTF
Set whether to allow the use of TrueType font compatible mode.
• ENABLE: Allow the use of TrueType fonts.
• DISABLE: Do not allow the use of TrueType fonts.
By enabling the TrueType font compatible mode, the bold TrueType font
will be printed in smaller pitch, and native graphic ‘F’ can be printed with
line terminator omitted.