Currency Discrimination Fitness Sorter SB - 2000 Service Manual
23
Counting
In AUTO mode, the machine starts to count the bill automatically as it detects the existence of the
bill in the hopper. In MANUAL mode, the machine will start to count the bill only if the bills are
placed into the hopper and START key is pressed. While counting, the machine will display the
number of the bills on LCD display and it stops working when it meets the conditions described as
below;
- No bills in the hopper
- Stacker is full.
- Rejecter is full.
- The number of the bills counted is the same as the batch number to be set in BATCH
mode.
- Errors have occurred.
If an error is occurred during operation and the machine stops, then an error message will be
displayed. To clear the error, press CLEAR key. The machine will try to solve the problem
automatically, but if it fails to clear a jam or there are some other mechanical errors, open the front
or rear cover and get rid of jammed bills and close the cover correctly. Then press the CLEAR key
again to clear error message.
Stop in operation
Press START button to stop operation while the machine is counting.
To restart, press CLEAR button.
To Next Page
Loading...
