OPM 100 en-GB 107
© Scania CV AB 2023, Sweden
Other
17.
Align the particulate filter outlet for the dif-
ferential pressure sensor with the mark.
Tighten the V-clamp and the band clamp
around the particulate filter. Tightening
torque, V-clamp, 20 Nm.
18. Clean the sealing surface on the end plate (3).
The surface should be free of gasket residue.
19. Fit the end plate and V-clamp (2) which hold
the end plate in place. Tightening torque, V-
clamp, 20 Nm.
20. Fit the V-clamp at the particulate filter outlet
(1). Tightening torque, V-clamp, 20 Nm.
21. Fit the exhaust gas temperature sensor (1).
Use 2 290 856 17 mm, Special sleeve, slot-
ted, 1/2" if necessary. Tightening torque, Ex-
haust gas temperature sensor, T4010, 30 Nm.
22. Connect the differential pressure sensor har-
ness-to-component connector (2).
Be careful when handling the sensor body. It is
sensitive and must not be bent or straightened.
Renew the sensor if it is bent.
To Next Page
Loading...
