Scanlab RTC 4 - Delivered Product; Package Contents; Manufacturer Information; About This Operating Manual

RTC
®
4 PC Interface Board
Rev. 1.3 e
1 Delivered Product
6
innovators for industry
1 Delivered Product
1.1 Package Contents
The contents of the package are listed in detail in the
“Package Description” file.
 Check the package for damage and confirm that
all parts have been delivered. If anything is
missing, please contact SCANLAB.
 Keep the packaging, including the antistatic bag
the RTC
®
4 board is delivered in, so that in case of
repair the board can be properly repackaged and
returned to SCANLAB.
1.2 Manufacturer
SCANLAB AG
Siemensstr. 2a
82178 Puchheim
Germany
Tel. +49 (89) 800 746-0
Fax: +49 (89) 800 746-199
info@scanlab.de
www.scanlab.de
1.3 About This Operating Manual
This operating manual is a part of the product. Please
read these instructions carefully before you proceed
with installation and operation of the RTC
®
4. If there
are any questions regarding the contents of this
manual, please contact SCANLAB (see previous
section).
Keep the manual available for servicing, repairs and
disposal. This manual should accompany the product
if ownership changes hands.
This manual refers to the following versions of the
RTC
®
4 software and firmware:
• DLL: RTC4DLL.DLL , version 400 or higher,
• DSP program files:
RTC4D2.HEX / RTC4D3.HEX ,
version 2.400 / 3.400 or higher,
•RTC
®
4 firmware: version 128 or higher.
The following commands return the current software
and firmware version numbers:
• get_dll_version (page 82);
• get_hex_version (page 83) and
• get_rtc_version (page 84)
Supplements To This Manual
The following RTC
®
4 supplementary manuals are
available from SCANLAB:
• "3D Software" manual
• "Processing-On-The-Fly Software" manual
• "I/O Extension Board" manual
• "correXion and CFMP" manual