Scanlab RTC 4 - Supported and Unsupported RTC 2 Commands

RTC
®
4 PC Interface Board
Rev. 1.3 e
10 Commands And Functions
125
innovators for industry
10.4 Supported and Unsupported
RTC
®
2 Commands
The RTC
®
4 emulates some RTC
®
2 commands for
compatibility. Though these emulated commands
can be used with the RTC
®
4, new application soft-
ware should only use the commands described in
chapter 10.
This section also specifies RTC
®
4 replacements for
those RTC
®
2 commands that are neither supported
nor emulated.
The following table provides an overview of
emulated RTC
®
2 commands and unsupported RTC
®
2
commands as well as appropriate RTC
®
4 replace-
ments.
Ctrl Command aut_change
Support status The RTC
®
4 emulates this RTC
®
2 command.
Replaced by auto_change (see page 75)
Function same as auto_change (see page 75)
Integration Pascal:
procedure aut_change;
C: void aut_change(void);
Basic: sub aut_change()
List Command field_jump
Support status This RTC
®
2 command is not supported by the RTC
®
4.
Replaced by home_position (see page 89)
Ctrl Command get_rtc2_mode
Support status This RTC
®
2 command is not supported by the RTC
®
4.
Replaced by The RTC
®
4 has no need to query the mode, which is now be set via the software command
set_laser_mode (see page 108) instead of hardware.
Ctrl Command get_rtc2_version
Support status This RTC
®
2 command is not supported by the RTC
®
4.
Replaced by get_rtc_version (see page 84)
Ctrl Command get_version
Support status This RTC
®
2 command is not supported by the RTC
®
4.
Replaced by get_hex_version (see page 83)