Scanlab RTC 4 - Core Operation Commands

RTC
®
4 PC Interface Board
Rev. 1.3 e
10 Commands And Functions
71
innovators for industry
Other Control Commands
get_dll_version ......................................... 82
(n_) get_hex_version ....................................... 83
(n_) get_rtc_version ......................................... 84
(n_) get_serial_number ................................... 85
(n_) home_position ......................................... 89
get_hi_data ............................................... 83
(n_) get_time ................................................... 86
(n_) set_piso_control ..................................... 111
(n_) auto_cal .................................................... 74
List Commands
Vector Commands
(n_) jump_abs .................................................. 90
(n_) jump_rel .................................................... 90
(n_) mark_abs .................................................. 98
(n_) mark_rel .................................................... 98
(n_) timed_jump_abs ..................................... 120
(n_) timed_jump_rel ...................................... 120
(n_) timed_mark_abs ..................................... 121
(n_) timed_mark_rel ...................................... 121
Arc Commands
(n_) arc_abs ...................................................... 73
(n_) arc_rel ....................................................... 73
Status Monitoring and Diagnostics
(n_) set_trigger .............................................. 117
External Control Inputs
(n_) set_control_mode_list ............................ 103
List Handling
(n_) set_end_of_list ....................................... 104
(n_) set_extstartpos_list ................................ 105
Synchronization Of Processing
(n_) set_wait .................................................. 118
Structured Programming
(n_) set_list_jump .......................................... 109
(n_) list_call ...................................................... 92
(n_) list_return ................................................. 94
(n_) list_nop ..................................................... 94
Setting The Laser Parameters
(n_) set_laser_timing ..................................... 108
(n_) set_firstpulse_killer_list .......................... 105
(n_) set_standby_list ...................................... 116
Setting The Scanner Parameters
(n_) set_laser_delays ...................................... 107
(n_) set_scanner_delays ................................. 113
(n_) set_jump_speed ..................................... 107
(n_) set_mark_speed ...................................... 109
Coordinate Transformations
(n_) set_matrix_list ........................................ 110
(n_) set_offset_list ......................................... 111
Direct Laser And Scan Head Control
(n_) laser_on_list .............................................. 91
(n_) laser_signal_on_list .................................. 92
(n_) laser_signal_off_list .................................. 91
(n_) z_out_list ................................................. 124
Scanning Raster Images (Bitmaps)
(n_) set_pixel_line .......................................... 113
(n_) set_pixel .................................................. 112
I/O Commands
(n_) clear_io_cond_list ..................................... 76
(n_) list_call_cond ............................................ 93
(n_) list_jump_cond ......................................... 93
(n_) set_io_cond_list ...................................... 106
(n_) write_8bit_port_list ................................ 122
(n_) write_da_x_list ........................................ 123
(n_) write_io_port_list ................................... 124
Other List Commands
(n_) long_delay ................................................ 98
(n_) save_and_restart_timer .......................... 101
(n_) set_wobbel ............................................. 118