Scanlab RTC 4 - Page 101

To Next Page

To Previous Page

RTC

4 PC Interface Board

Rev. 1.3 e

10 Commands And Functions

101

innovators for industry

Ctrl Command release_wait

Function resumes execution of a list that was interrupted by a set_wait command

Result wait state as an unsigned 16-bit value

Integration Pascal:

procedure release_wait;

void release_wait(void);

Basic:

sub release_wait()

Comments • The command release_wait can only be used if the RTC

4 is actually in a wait state

(i.e. a wait marker was reached and processing has stopped).

• The command release_wait resets the wait_word to zero.

References set_wait, get_wait_status

Ctrl Command restart_list

Function enables the laser again and resumes execution of a list that was interrupted using the

command stop_list.

Integration Pascal:

procedure restart_list;

void restart_list(void);

Basic:

sub restart_list()

References stop_list

Ctrl Command rtc4_count_cards

Function returns the number of detected RTC

4 boards

Result number of RTC

4 boards as an unsigned 16-bit value

Integration Pascal:

function rtc4_count_cards: word;

unsigned short rtc4_count_cards(void);

Basic:

function rtc4_count_cards()%

List Command save_and_restart_timer

Function stores the current value of the RTC

4 timer and resets it to zero

Integration Pascal:

procedure save_and_restart_timer;

void save_and_restart_timer(void);

Basic:

sub save_and_restart_timer ()

Comments • The stored timer value can be read by the get_time command.

• The command is useful for measuring the marking time of a marking process.

References get_time

Main Page

Scanlab RTC 4 - Page 101

Table of Contents

Related product manuals