Scanlab RTC 4 - Commands and Functions; Overview of Commands

RTC
®
4 PC Interface Board
Rev. 1.3 e
10 Commands And Functions
69
innovators for industry
10 Commands And Functions
10.1 Overview
The tables on page 70 and page 71 show the
complete RTC
®
4 command set (control commands
and list commands; also see chapter 4.1 "Software
Concept", page 12). The commands are listed
according to their intended use. The page numbers
refer to chapter 10.3 "Command Set".
Multi-Board Commands
All commands marked (n_) also exist in a version
for multiple RTC
®
4 boards installed in one computer.
See chapter 5.4, page 43 for detailed information
about these multi-board commands.
Compatibility
A number of commands from the RTC
®
2 command
set are provided for compatibility. These commands
are listed in chapter 10.4 "Supported and Unsup-
ported RTC
®
2 Commands", page 125.