www.schaerer.com Programming
BASCAP_TOUCHIT_EN
V04 | 10.2018
70
21.2) Service counters Lists all service counters.
The following counters are listed:
• Number of piston strokes per brewing
unit.
• The operating hours of the grinders and
water pump.
• The runtime of the air pump and mixer.
• The relay switching procedures for cof-
fee, hot water and steam.
• The grind quantity of the grinders.
To reset a counter:
► Select the [Clear] (A) field.
The respective counter is reset to (0).
The field appears.
► Store the reset counter using the
field.
► Select the [Back] (B) field.
This takes you back to the "Counters
and statistics" menu.
See "System" - "Restore/backup" for further
information on restoring counters and statis-
tics.
The counter is
reset to (0).
The "Service counters"
can only be used using the
SERVICE card.
The service counters can
be displayed using the
SERVICE card and the
CHEF card.
24.0) Last filter change Enter the date of the last filter change.
► Mark the day, month or year range.
► Enter the date using the arrow buttons
(up/down).
► Save the entry with the field that ap-
pears.
The last filter change date is dis-
played.
The entry field is deactivated (grey).
See "System" - "Restore/backup" for further
information on restoring counters and statis-
tics.
Day, month and
year
The parameter remains
deactivated until the cur-
rent date is no longer iden-
tical to the set date.
See "Configuration" -
"Date/time/alarm" on set-
ting the filter change pa-
rameters.
24.1) Last service Enter the date of the last service that was
performed.
► Mark the day, month or year range.
► Enter the date using the arrow buttons
(up/down).
► Save the entry with the field that ap-
pears.
The date of the last service request is
displayed.
The entry field is deactivated (grey).
See "System" - "Restore/backup" for further
information on restoring counters and statis-
tics.
Day, month and
year
The parameter remains
deactivated until the cur-
rent date is no longer iden-
tical to the set date.
See "Configuration" -
"Date/time/alarm" on set-
ting the service request
parameters.
Parameters: Counters and statistics
Display text Description Setting range Notes
To Next Page
Loading...
Need help?
General
