Schiedel CM03 - Page 70

7 Parameter menu
Operating Manual 90° ACTUSAFE CMF(S)QT
OM-ENGLISH-Failsafe-QT-16xx-V2.00-2022.03.01
continued from previous page
Parameter Menu item Sub-menu item
Default UL
Read
Default UL
Write
P13.6 Positioner Live zero detect. 2 4
P13.7 Positioner Emergency pos. 1 3
P13.8 Positioner Calib.setpoint 2 4
P13.9 Positioner Min.Impuls 2 4
P13.10 Positioner Period 2 4
P13.11 Positioner Begin pos. (a0) 2 4
P13.12 Positioner End pos. (e0) 2 4
P13.13 Positioner Begin setp. (a1) 2 4
P13.14 Positioner End setp. (e1) 2 4
P13.15 Positioner Calib.setpoint offset 2 4
P13.16 Positioner Hysteresis 2 4
P14.1 PID-controller Function 2 4
P14.2 PID-controller Ext.setpoint 2 4
P14.3 PID-controller Setpoint value 2 4
P14.4 PID-controller Begin (at 0%) 2 4
P14.5 PID-controller End (at 100%) 2 4
P14.6 PID-controller Proportional 2 4
P14.7 PID-controller Integral 2 4
P14.8 PID-controller Differential 2 4
P14.9 PID-controller Offset 2 4
P14.12 PID-controller Live zero detect. 2 4
P14.13 PID-controller Cal.ext.act.val 2 4
P14.14 PID-controller Process begin 2 4
P14.15 PID-controller Process end 2 4
P14.16 PID-controller Process comma shift 2 4
P14.17 PID-controller Process unit 2 4
P14.18 PID-controller Dead band 2 4
P16.1 Stroketest Stroketest 2 4
P16.2 Stroketest Start position 2 4
P16.3 Stroketest Test range 2 4
P16.4 Stroketest Resting time 2 4
P16.5 Stroketest Speed Open 2 4
P16.6 Stroketest Speed Close 2 4
P16.7 Stroketest Time trigger 2 4
P16.8 Stroketest Max. time 2 4
P16.9 Stroketest Start Time 2 4
P16.10 Stroketest Start Test 2 4
P17.1 Characteristic Torque Open 2 4
P17.2 Characteristic Torque Close 2 4
P17.3 Characteristic Speed Open 2 4
P17.4 Characteristic Speed Close 2 4
P17.5 Characteristic Valve 2 4
P18.1 Identification KKS-Number 2 4
P19.6 System Calib.IST 2 4
P19.7 System Calib.SOLL 2 4
P19.8 System Calib.EIST 2 4
P19.12 System LCD Contrast 2 4
P19.15 System Welcome Menu 4 4
P19.21 System LED Function 1 3
continued on next page
70