Setup Menu
62 - GT-Series Terminal User’s Guide
CmdLine Setup
Enables or disables command line interface (CLI) access to
the terminal. The display of this menu will indicate the cur-
rent state of the CmdLine Setup option. If it is disabled,
press Enable to enable CLI access. If it is enabled, press
Disable to disable it. This option should normally be dis-
abled for security reasons.
Default: Enabled
Range: None
Dependencies: None
Who: A terminal administrator, appli-
cation developer/tester or any
individual under the guidance of
a technical support representa-
tive can disable or enable CLI
for troubleshooting, testing or
debugging purposes.
1. Log into the terminal as an administrator.
See “Administrator Authentication” on page 47 for more information.
2. Press Setup Menu.
3. Press General Setup.
4. Press CmdLine Setup.
5. Press Enable/Disable.
Set Time&Attend
Enables or disables time and attendance mode for the
terminal. When enabled, the user will be prompted to
punch in or out before the hand verification. When
disabled, the user will not be given the choice to punch in
or out and the terminal or host will automatically punch the
user in or out. This menu will display the current state of
the Time and Attendance Mode option.
Default: Disabled
Range: None
Dependencies: None
Who: A terminal administrator should
set this option during initial
setup of the terminal.
1. Log into the terminal as an administrator.
See “Administrator Authentication” on page 47 for more information.
2. Press Setup Menu.
3. Press General Setup.
4. Press Time&Attend.
5. Press Enable/Disable.
To Next Page
Loading...