Command Menu Reference
GT-Series Terminal User’s Guide - 67
Set CR Terminator String
Defines a barcode credential’s terminator string. Press Set
CR Terminator String and set the string as necessary.
Default: 3232000
Range: None
Dependencies: None
Who: A terminal administrator can
define barcode terminator
strings to comply with site spec-
ifications.
1. Log into the terminal as an administrator.
See “Administrator Authentication” on page 47 for more information.
2. Press Setup Menu.
3. Press General Setup.
4. Press More.
5. Press Set CR Terminator String.
6. Enter the CR terminator string.
7. Press Enter.
Set Beeper
Enables or disables the audible beep on the terminal. The
display of this menu will indicate the current state of the
beeper. If it is disabled, press Enable to enable the beeper.
If it is enabled, press Disable to disable it.
Default: Enabled
Range: None
Dependencies: None
Who: A terminal administrator can
enable or disable the beeper at
any time.
1. Log into the terminal as an administrator.
See “Administrator Authentication” on page 47 for more information.
2. Press
3. Press Setup Menu.
4. Press General Setup.
5. Press Set Beeper.
6. Press Enable or Disable.
To Next Page