Schlage PIB300 - System Components

6 • Schlage • Schlage Express Soware Manual
Introduction
System Components
Before you start using the Schlage Express Software, take a moment to get to know the components that you will be handling.
AD 200 Series Locks
The AD-200 Series Locks are battery powered ofine locks that
can use various credentials (PIN, Prox, Mag stripe, Card +
PIN). The AD-200 locks are modular and read different
credentials with additional hardware add-ons.
AD 201 Series Locks
The AD-201 Series Locks are battery powered ofine locks that
support the FIPS 201 75-bit PIV credential.
CO-200 Series Locks
The CO-200 Series locks are battery powered ofine locks that
can use various credentials.
CO-220 Series Locks
The CO-220 Series locks are battery powered ofine locks that
can use various credentials. It also allows immediate local
lockdown by simply pushing the button on the remote fob from
anywhere in the classroom. An illuminated visual indicator
located on the interior side of the lock provides instant
verication that the door is secured. The CO-220 provides a
localized solution for schools that want to upgrade without the
cost or complexity of a networked system.
CT5000
The CT5000 is an ofine single opening controller.
BE367 Deadbolt
The battery-powered BE367 Deadbolt is an electronically
programmable deadbolt lock. It is programmed to accept
iButtons. When an iButton is presented to the BE367 Deadbolt,
the lock reads the electronic signature of the iButton and if the
lock has been programmed to accept that signature, the lock
will operate.
Legacy KC2 5000 and 9000
The battery-powered King Cobra is an electronically
programmable lockset that can store PIN codes and iButtons.
CM993
The CM993 is a computer managed retrot trim and interfaces
with Von Duprin 98 & 99 Series Exit Devices. Models of
CM993 are available that will accommodate a variety of
credentials, i.e., mag stripe card, HID prox card, iButton and
keypad.
CT1000 Controller
The CT1000 Controller is an ofine, hardwired, universal
controller that supports 1000 users and 1000 audit events The
CT1000 supports iButtons, mag stripe cards, PIN codes and
HID prox cards.
HHD
Using the HHD you can transfer information to and from the
locks without having to return multiple times to the desktop PC.
When connected together, the HHD and the desktop PC
transfer new or updated programming and audit trail
information between each other. Will connect to AD and CO
series locks with the included USB cable. Can connect to other
locks with the CIP add on. Works with all credentials.
Schlage Express Soware
Schlage Express software is an easy-to-use system that
provides access control and key management for both
multi-family residences and commercial facilities.
Backup Facility Files
Always back up your Schlage Express facility les. Back up the
les to diskette, CD, network or ash drive. The backup facility
les are a safeguard in case theft, re, computer virus, or other
disaster should strike the desktop PC that houses your
database.
User Credentials
User Credentials lets you lock or unlock a variety of locks
which have been programmed to accept the credential.
• Red iButtons are for programming.
• Black iButtons are for user access.
• All Legacy KC2 locks will also accept a Black iButton as a
programming key. You can only use a Red iButton to
program a BE367 Deadbolt.
HH-USB Cable
This cable comes with the HHD. It is used to connect the HHD
to a desktop PC and to USB enabled locks (CO and AD
series).
HH-SERIAL Cable
This is an additional cable that can be purchased separately
from the HHD that connects the HHD to the CIP.
Computer Interface Peripheral (CIP)
The CIP is used to connect to non-USB enabled locks. Use the
CIP to transfer data between the non-USB enable lock and the
HHD.