Schmid Watson - Entity MIB (RFC 2737); Rmon (Rfc 2819); If Mib (Rfc 2863); SNMP Notification MIB (RFC 3413)

Watson-Ethernet-Manual.doc
Version 3.3-01
Watson Ethernet
Operating Manual
Revision: 2010-01-20
8-7
8.2.4 Entity MIB (RFC 2737)
The Entity MIB contains data structures modeling the subrack and the plug-ins in
the subrack.
Implemented data structures:
 entPhysicalTable
 entLogicalTable
 entLPMappingTable
 entAliasMappingTable
 entityGeneral group
Implemented notifications:
 entConfigChange
8.2.5 RMON (RFC 2819)
The RMON MIB contains Ethernet statistics counters.
Implemented data structures:
 etherStatsTable. The etherStatsPkts1024to1518Octets counter
also counts packets from 1519 up to the maximum packet size supported by
the Watson Ethernet plug-in card.
8.2.6 IF MIB (RFC 2863)
The Interfaces MIB contains a table of all interfaces of the Watson Ethernet plug-
in card and the hierarchical relations between them. Note that the Ethernet inter-
faces of the Watson Ethernet tabletop modems are not visible in the ifTable.
Implemented data structures:
 ifTable (Default Context and Card Context)
 ifStackTable (Default Context and Card Context)
Implemented notifications:
 linkDown
 linkUp
8.2.7 SNMP Notification MIB (RFC 3413)
The SNMP Notification MIB allows to select groups of targets that are to receive
notifications or traps. Each target is defined in the SNMP Target MIB.
Implemented data structures:
 snmpNotifyTable