Schmid Watson - Monitor Command Structure; Welcome Screen; Menus; Table 6-2: Monitor Command Subsets

Watson Ethernet
Operating Manual
Watson-Ethernet-Manual.doc
Version 3.3-01
6-4
Revision: 2010-01-20
6.5 Monitor Command Structure
6.5.1 Welcome Screen
After connecting the Terminal/PC the welcome screen is shown with information
about the modem type and Firmware Version, e.g.:
Watson 5 SHDSL Ethernet
ZRH01
Monitor V3.0
Copyright (C) 2001-2006 by Schmid Telecom AG Zuerich, Switzerland
+-----------------------+
| Main Menu |
+-----------------------+
1. Performance management (PM)
2. Fault and maintenance management (FMM)
3. Configuration management (CM)
4. Security and remote management (SM)
5. Exit
LTU_01>
To select the desired sub-menu, type the appropriate number.
The available Monitor commands are described in chapter 7.
Notes:
 The Exit command is only available on the plug-in if it is installed in a sub-
rack or accessed via Telnet..
 To address another plug-in in the subrack after Exit type %nn (nn = slot
number)
6.5.2 Menus
The Monitor menu is structured in the following sub-sets:
Subset
Short-form
Performance management
PM
Fault and maintenance management
FMM
Configuration management
CM
Security and remote management
SM
Table 6-2: Monitor Command Subsets